Characteristics of Ideal Working Fluid in Vapour Power Cycle

By | October 29, 2023
We all know any thermodynamic power cycle depends on a working fluid for the transfer of heat from the source to the point where it is converted to some useful work.

Steam Power

Picking a working fluid for any vapour power cycle is not a random decision, as in case of any malfunction, it can be dangerous to human life and can cause huge maintenance cost. And also in general, an inappropriate working fluid will result in the high operating cost of the plant.
While choosing a working fluid for a vapour power cycle one should keep following factors (Characteristics of Ideal Working Fluid in Vapour Power Cycle) in his mind. These factors suggest the properties of working fluids for a trouble free and efficient vapour power cycle.
1. The fluid should have high critical temperature so that the saturation pressure at the maximum permissible temperature is relatively low. It should have a large enthalpy of evaporation at that pressure.
2.  The saturation pressure at the temperature of heat rejection should be above atmospheric pressure so as to avoid the necessity of maintaining vacuum in the condenser.
3.  The specific heat of the liquid should be small so that little heat transfer is required to raise the liquid to the boiling point.
4.  The saturated vapour line of the T-s diagram should be steep, very close to turbine expansion process so that excessive moisture does not appear during expansion.
5.  The freezing point of the liquid should be below room temperature, so that it does not get solidified while flowing through the pipelines.
 6.  The fluid should be chemically stable and should not contaminate the material of construction at any temperature.
7.  The fluid should be nontoxic, noncorrosive, not excessively viscous, and low in cost.

Featured image source:

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.